AgCam®/EnduraCam®/RazerCam™ Cameras mate to DT 6-pin Male

This adapter cable allows for the input of four (4) AgCam®/EnduraCam®/RazerCam™ cameras into one (1) DT 6-pin male.

This AGCO authorized harness splitter cable was developed and is manufactured, tested, and supported right here in the USA by Dakota Micro®. A convenient but ruggedized solution that enables you to input four (4) AgCam®/EnduraCam®/RazerCam™ CVBS PAL camera per cable into equipment using it’s existing monitor and/or pre wired Dakota Micro® AHD 9″ quad monitor. A variety of extension cables lengths can connect directly to the this harness splitter allowing you at run and mount cameras to your desired locations. Dakota Micro® has designed, tested, and verified the compatibility with the following 3rd party monitors; AGCO NT01, Tyton, Vario Terminal 10.4. This cable plugs directly into the one (1) DT 6-pin male located below or on the back of the AGCO equipment cab. Cameras are powered directly from the harness splitter and require no additional power source.